Recently Completed Jobs by Politon

January 4, 2022 | Forney, TX

This Wifi installation at a church in Forney was pretty typical when installing cable and wifi in regards to difficult wire paths, multiple obstructions, and few penetrations between the floors. We ended up getting permission to run our cable up the inside of a column that extended to the thirty-foot ...

December 16, 2021 | Arlington, TX

We went on-site thinking this could possibly be a demarc extension issue. What we eventually discovered as the issue ended up being a pretty simple solution. Once we gained access to the network closet and located the switch that was no longer seen online by the network operations team we ...

December 3, 2021 | Dallas, TX

Using the access path from the main cabling run out of the data closet, we were able to get the new cables into the office area and fish them down the walls into position. The tricky part of this job was getting the cables from the data closet to the ...

November 12, 2021 | Fort Worth, TX

Baumann asked us to install two Quad data outlets for future use on some new cubicle workstations. We pulled the cable out the opening with about twenty feet of slack and a four-square box with a faceplate on it. We also installed a dual data run in the same room ...

September 30, 2021 | Plano, TX

We provided technical support to install the customer's hardware solutions for Wifi, network switches and routers, network cabinets, and UPS with extended batteries. This was a fairly small office so the network cabling for the wifi was very easy. We installed four wifi access points for the customer. They had ...

September 28, 2021 | Dallas, TX

The solution we provided was a two-strand single-mode fiber from their dmarc room to their network cabinet in the MDF closet. We installed LC connectors on both ends and certified the connection with our Owl Fiber Tester. The customer asked us after the fiber installation if we could assist him ...

September 10, 2021 | Frisco, TX

Our new customer in Frisco wanted us to install a four-post data rack they already had into their new data closet on the 4th floor. We installed approximately 64 Cat 6 data cables along with seven Cat 6A cables. The customer requested Cat 6A for all of their Wifi access points. They ...

September 10, 2021 | Denton, TX

We have worked several tickets very similar to this one for our customer. They have Invisalign fiber installed on the surface of their walls. This was a fiber retrofit method after the apartments had been built. It's a great product for this solution but the downside is if you run ...

August 31, 2021 | Denton, TX

To get to a resolution on this trouble ticket we worked for them was a multi-step process. First, we had to do a port audit which involved patching in a laptop doing a continuous ping into every network switch port in each of ten network closets across the property. This ...

August 27, 2021 | Carrollton, TX

We ended up repairing the LC connectors on six strands of the single-mode fiber. Luckily the cable was lowered to the ground which allowed easy access to the cable the challenging part was there was very little slack to work with. To reinforce the fibers we had to use heat ...

August 27, 2021 | McKinney, TX

We ended up installing all the data cabling, data rack, network switch, Wifi access point, and NVR. We helped the doctor get her office up and running. The customer provided their own security cameras and NVR but we installed the cameras and the cabling back to the NVR. There were ...

August 6, 2021 | Fort Worth, TX

We installed a SIP gateway paging solution that allowed their Ring Central phones to be able to page out to a traditional analog paging system. The customer wanted us to move one existing 5-watt Valcom paging horn and to add one new horn. We provided a Valcom VRCPA (Valcom Ring ...

August 5, 2021 | North Richland Hills, TX

The customer had has come out again to pull a new fiber between these two buildings into the new conduit that was installed much deeper underground. The school has also marked the path of this new conduit and fiber for future reference. The problem in the past is they did ...

August 3, 2021 | Dallas, TX

Our contact wanted to update their network cabling to all Cat 6 from what they currently have which is Categroy 5. They also wanted us to clean up their data rack and install wire management.

July 19, 2021 | Fort Worth, TX

There were several solutions we installed here in addition to the new Cat 6 data cabling. We installed wall mount brackets with Cat 6 HDMI extensions from their NVR to allow two employees to view the security cameras from their offices. We provided two sets of HDMI extenders by Calrad. The customer ...